Charnwood W583 Planer Thicknesser 250mm X 195mm – Poolewood

Charnwood W583 Planer Thicknesser 250mm x 195mm

The Charnwood W583 Planer Thicknesser 250mm x 195mm is a solid and well finished planer thicknesser for the busy workshop.

• Precision Ground Cast Iron Beds
• 2hp Induction Motor
• 3 Knife Cutterblock for Superior Finish
• 10″ Planing Capacity
• 10″ x 7″ Thicknessing Capacity
• Rubber Coated Outfeed Roller
• 100mm diameter Dust Extraction Outlet
• Optional Wheel Base Available

The Charnwood W583 Precision ground cast iron beds and a long tilting fence which can be positioned at any point across the table therefore make this machine a delight to use. The 3 knife cutterblock is powered by a 2hp induction motor and is capable of a cut up to 5mm deep in a single pass.

To gain better visibility and access for thicknessing, both of the planing beds are hinged and swing out of the way, without using any tools. A dust hood / cutter guard is then swung into position and the conversion to Thicknesser is complete.

The feed roller drive, which features a rubber outfeed roller, can be disengaged during planing operations to save motor power and general wear on the machine.

Supplied with 3 knives, 100mm dust extraction outlet, 4 adjustable feet, cable and plug.
The Charnwood W583 planer thicknesser will run off any standard 13amp supply.

It is essential to use dust extraction with a planer thicknesser. The extractor removes all the dust and chips which will otherwise build up, causing a blockage and eventually damage to the machine. Using an extractor also increases the life of the knives.